Warranty And Liability; Organisational Measures - HYDAC ELECTRONIC CANopen HLT 2550-L2 Notice D'utilisation

HLT 2550-L2 CANopen
Where there is a danger of physical injury and damage to property arising
from jerking displacement of the measuring system !
-
WARNING !
-

2.5 Warranty and liability

The General Terms and Conditions ("Allgemeine Geschäftsbedingungen") of HYDAC
ELECTRONIC GMBH always apply. These are available to the operator with the order
confirmation or when the contract is concluded at the latest. Warranty and liability claims
in the case of personal injury or damage to property are excluded if they result from one
or more of the following causes:
• Non-designated use of the measuring system
• Improper assembly, installation, start-up and programming of the measuring system
• Incorrectly undertaken work on the measuring system by unqualified personnel
• Operation of the measuring system in spite of technical defects
• Mechanical or electrical modifications to the measuring systems undertaken
autonomously
• Repairs carried out autonomously
• Third party interference and Acts of God

2.6 Organisational measures

• The user manual must always be kept accessible at the place of use of the measuring
system.
• In addition to the user manual, generally applicable legal and other binding accident
prevention and environmental protection regulations must be paid attention to and must
be mediated.
• The respective applicable national, local and system-specific provisions and
requirements must be paid attention to and mediated.
• It is mandatory for the operator to inform personnel on special operating features and
requirements.
• The personnel instructed to work with the measuring system must have read and
understood the user manual, especially the chapter "Basic safety instructions" prior to
commencing work.
• The nameplates and any prohibition or instruction symbols applied on the measuring
system must always be maintained in a legible state.
• Repairs may only be undertaken by the manufacturer or a facility or person authorized
by the manufacturer.
Edition: 2017-08-08
A plausibility check of the measuring system values must be
performed through the downstream control system.
It is mandatory for the operator to integrate the measuring system
into his own safety concept.
HYDAC ELECTRONIC GMBH
7
E
Part No.: 669955