Warranty And Liability; Organisational Measures - HYDAC ELECTRONIC HLT 1100-R2 Série Notice D'utilisation

8

2.5 Warranty and liability

The General Terms and Conditions ("Allgemeine Geschäftsbedingungen") of HYDAC
ELECTRONIC GMBH always apply. These are available to the operator with the order
confirmation or when the contract is concluded at the latest. Warranty and liability claims in
the case of personal injury or damage to property are excluded if they result from one or
more of the following causes:
• Non-designated use of the measuring system
• Improper assembly, installation, start-up and programming of the measuring system
• Incorrectly undertaken work on the measuring system by unqualified personnel
• Operation of the measuring system in spite of technical defects
E
• Mechanical or electrical modifications to the measuring systems undertaken autonomously
• Repairs carried out autonomously
• Third party interference and Acts of God

2.6 Organisational measures

• The user manual must always be kept accessible at the place of use of the measuring
system.
• In addition to the user manual, generally applicable legal and other binding accident
prevention and environmental protection regulations must be paid attention to and must be
mediated.
• The respective applicable national, local and system-specific provisions and requirements
must be paid attention to and mediated.
• It is mandatory for the operator to inform personnel on special operating features and
requirements.
• The personnel instructed to work with the measuring system must have read and understood
the user manual, especially the chapter "Basic safety instructions" prior to commencing work.
• The nameplates and any prohibition or instruction symbols applied on the measuring system
must always be maintained in a legible state.
• Repairs may only be undertaken by the manufacturer or a facility or person authorized by the
manufacturer.
Status: 2018-01-03
HYDAC ELECTRONIC GMBH
HLT 1100-R2- xxx-F13-xxxx-S2PD-000
Part No.: 669939