Personnel Qualification; Obligations; Safety Information - HYDAC ELECTRONIC CANopen HLT 2550-L2 Notice D'utilisation

8

2.7 Personnel qualification; obligations

• All work on the measuring system must only be carried out by qualified personnel.
Qualified personnel includes persons, who, through their training, experience and
instruction, as well as their knowledge of the relevant standards, provisions, accident
prevention regulations and operating conditions, were authorized by the persons
responsible for the system to carry out the required work and are able to recognize and
avoid potential hazards.
• The definition of "Qualified Personnel" also includes an understanding of the standards
VDE 0105-100 and IEC 364 (source: e.g. Beuth Verlag GmbH, VDE-Verlag GmbH).
• Define clear rules of responsibilities for the assembly, installation, start-up and
operation. It is obligatory to provide supervision for trainee personnel!
E

2.8 Safety Information

WARNING !
CAUTION !
Edition: 2017-08-08
• Destruction, damage or malfunctions of the measuring system !
Wiring work or opening and closing electrical connections must be
-
carried out in de-energized condition only.
Do not carry out welding if the measuring system has already been
-
wired up or is switched on.
Ensure that the area around the assembly site is protected from
-
corrosive media (acid, etc.).
Avoid any shocks (e.g. hammer-blow) on the measuring system
-
while mounting.
Do not bend the sensor rod
-
Do not install the measuring system next to magnetic fields.
-
Do not open the measuring system.
-
The measuring system contains electrostatically endangered circuit
elements and units which can be destroyed by improper use.
Touching the measuring system connection contacts with bare fingers
must be avoided, resp. the appropriate ESD protective measures are
applicable.
• Disposal
If disposal has to be undertaken at the end of a device's lifespan, the
respective applicable country-specific regulations must be taken into
consideration.
• Device designs
The technical details for customer-specific device designs, including
connection technology, may differ from the designs described here and in
the interface-specific user manuals.
The technical details for customer-specific device designs, including
connection technology, may differ from the designs described here and in
the interface-specific user manuals. In case of doubt, the manufacturer
should be consulted, specifying the item number.
HYDAC ELECTRONIC GMBH
HLT 2550-L2 CANopen
Part No.: 669955