SMA MLX Série Guide D'installation page 3

IMPORTANT SAFETY INSTRUCTIO...
IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS
Safety Message Types
The following symbols are used in this document:
DANGER
Indicates a potentially hazardous situation which will
result in death or serious injury.
WARNING
Indicates a potentially hazardous situation which could
result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation which could
result in minor or moderate injury. It may also be used
to alert against unsafe practices.
NOTICE
Indicates important information, including situations
which may result in damage to equipment or property.
General Safety
CAUTION
This manual contains important instructions that shall be
followed during installation and maintenance of the MLX
inverter.
NOTICE
BEFORE INSTALLATION
Check for damage to equipment and packaging. If in
doubt, contact the supplier before commencing instal-
lation.
WARNING
INSTALLATION
For optimum safety, follow the steps described in this
document. Keep in mind that the inverter has 2 voltage-
carrying sides; the PV input and the AC grid.
DANGER
DISCONNECTING THE INVERTER
Before starting work on the inverter, switch off AC at the
mains switch and PV using the PV load switch. Ensure
that the inverter cannot be unintentionally reconnected.
Use a voltage tester to ensure that the unit is discon-
nected and voltage free. The inverter can still be charged
with very high voltage at hazardous levels even when it
is disconnected from AC grid and solar modules. Wait at
least 5 minutes following disconnection from grid and
PV panels before proceeding.
L00410644-01_2q / Rev. date: 2014-06-02