Erreka MAGIC MA210 Manuel De L'installateur page 59

Position the angle on the wall
1 1
Connect the operator to the control board (VIVO-D203)

Before making any electrical connections,
check the control board instructions manual.

Before carrying out any door movement,
ensure there is no person or object in the radius
of action of the
mechanisms.

Ensure the earth wire of the motors is
connected to the control board earth terminal.
door and the drive
1 Mark the points (1) to drill in the pillar.

Before marking the position of the holes, ensure
the assembly positions are respected (see "Fig. 4
Assembly position for the frame and the integrated
operator").
2 Drill the points marked.
3 Position the angle (2) and secure it to the material
upon which the angle is attached, using appropriate
screws (3).
4 Attach the upper pin (1) to the angle (2) using the
pressure washers (3), screws (4) and nuts (5).
5 Position the water cover (6) using the corresponding
screws.
MAGIC built-in electromechanical operator
INSTALLATION
55