Erreka MAGIC MA210 Manuel De L'installateur page 55


Procedure
Position the base plate
1 1
Make the orifices for the attachment of the motor
1 Mark the points (1) to drill.
2 Drill the points marked.
3 Position the plate (2) and secure it using appropriate
1 Position the template (1) supplied with the operator,
2 Drill the four orifices (3) where the motor will be
Ø
10,5mm
P249B

Before marking the position of the holes, ensure
the assembly positions are respected (see "Fig. 4
Assembly position for the frame and the integrated
operator").
screws (3).
ensuring the lower edge of the template coincides
with the base of the frame (2).
attached.

Use 10.5 mm broach.
MAGIC built-in electromechanical operator
INSTALLATION
51