IMPORTANT SAFETY INFORMATION
NOTICE
Do not recirculate exhaust air inside cabinet when multiple
condensing units are installed together. Intake air should
enter from outside of cabinet.
Transport and install unit in upright position only. Failure
to do so may result in damage to the refrigeration system.
Use caution and avoid hitting condensing unit hoses/lines
when installing unit. Damage caused during installation is
not covered under warranty.
Do not locate unit in area with excessive air movement
around unit. Avoid areas that may be subject to active air
movements or currents (i.e., near exhaust fans/hoods, air
conditioning ducts, and exterior doors).
Do not locate unit in an area subject to excessive
temperatures or grease from grills, fryers, etc. Excessive
temperatures could cause damage to the unit.
MODEL DESIGNATION
B = Hardcoat Surface, Built-In, Bottom-Mount
SBF = Stone Surface, Built-In, Top-Mount
U = Under Counter-Mount
R = w/ Remote Condensing Unit
Stone Surface, Built-In, Bottom-Mount
R = w/ Remote Condensing Unit
C S B R - x x - x
Cold Shelf
X = Shelf Only
C S S B R - x x x x
Cold Shelf
X = Shelf Only
Damage to any countertop material caused by heat or cold
generated from Hatco equipment is not covered under
the Hatco warranty. Contact manufacturer of countertop
material for application information.
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch the finish of the unit,
marring its appearance and making it susceptible to soil
accumulation.
Do not use steel wool for cleaning. Steel wool will scratch
the finish.
Do not use harsh chemicals such as bleach, cleaners
containing bleach, or oven cleaners to clean the unit.
Clean unit daily to avoid malfunctions and maintain
sanitary operation.
This unit is intended for commercial use only—NOT for
household use.
Cooled Depth of Shelf:
F = 15-1/2" (394 mm)
I = 19-1/2" (495 mm)
S = 24" (610 mm)
Cooled Width of Shelf (inches)
Depth of Shelf (inches)
Width of Shelf (inches)
4
English
NOTICE
Form No. CSRM-0220