Change And Save Parameter Values - Komet NikiVac Notice D'utilisation

Installation and Putting into Operation
6.3

Change and save parameter values

When you switch on the machine using the master switch, the machine enters
Standby Mode, the cover is open.
 The display shows OO.
You can now

work with the preset program

change and save the parameter values.
- Select the parameter you want to change. Press the relevant parameter
button:
VAC STOP: Evacuation time
GAS ON/OFF: Gas flush time
SEAL: Sealing time
 The display shows the current parameter value.
Change the value of the parameter using the
-
Pressing and holding the button changes the value first in small increments
and then in larger increments.
There are two ways to save the settings:
-
1. Press the parameter button again or do not press any buttons for approx. 3
seconds.
 The display flashes twice to confirm that the settings have been saved.
 The machine is now in Standby Mode.
 The display shows OO.
2. Close the cover of the vacuum chamber.
 The display flashes twice to confirm that the settings have been saved.
 The machine now starts the work cycle.
 The machine uses the new parameter values.
Operating Instructions - Translation
or buttons.