Installation And Putting Into Operation; General Information - Komet NikiVac Notice D'utilisation

Installation and Putting into Operation

6 Installation and Putting into Operation
6.1

General Information

Danger!
Electric shock possible!

Spray water and steam jets in the operating site are forbidden.

Only use authorised mains power connectors.

Check that the details on the type label on the machine correspond
with the electrical connection at the operating site for the machine.

The machine may not be connected in the event of any deviations.

Only have work carried out on the electric power supply by a
qualified electrician.
Warning !

Keep the device out of reach of children.

The machine may not obstruct emergency exits.

Heat accumulation and risk of fire!
Keep the ventilation slots free (a distance of more than 10 cm).

Do not place the machine close to flammable objects.
Notice !

Never place the machine on or against a heat source.

Damage may occur to the vacuum pump when operated at ambient
temperatures of < 10°, fill using low-viscosity oil.
The surrounding has to be dry and well ventilated. Please use the standards for
environment conditions cited in chapter: "Technical Data".

Set up the machine so that it is horizontal and secure.

Remove the transport locks (e.g. foam inserts).

Check the oil reading for the vacuum pump. Wherever necessary, top up with oil.
Proceed as set out in the chapter "Maintenance and Troubleshooting".

Plug in the main electrical supply plug to the power connection.
Operating Instructions - Translation
6.2 Operating and display elem
Control board with vacuum gauge
Important!

All settings are saved e
Master switch

To switch on the
- Switch to 1

Standard
To switch off: Sw
Important!

Wait about 5 seconds a
machine back on again
operate correctly.