Komet NikiVac Notice D'utilisation page 46

Maintenance and Troubleshooting
8.3 Oil Change
Danger!
Electric shock possible!

Pull out the main power plug before starting work!
Caution!

Handle and dispose of the used oil and the oil filter in accordance
with the valid conditions.
Oil type to be used, see chapter: "Technical Data"
When changing the oil, the pump must be operationally warm, switched off and
ventilated to atmospheric pressure (no more vacuum in the chamber).

Unplug the machine from the power connection.

Remove the insertion plates from the chamber.
Important !

First loosen the gas pressure spring and then remove the 2 large
screws on the casing of the machine.
Operating Instructions - Translation

Remove the 5 small screws on the
service lid on the backside of the
machine with an Allen key.
 You can remove the service
lid.
1

Remove the oil filler screw.

Let the used oil out through the oil

Screw back down the oil drain scr

Refill the fresh oil until the MAX m

Close up the oil inlet using the oil

To close the casing, proceed in re
2