Komet NikiVac Notice D'utilisation page 37

Installation and Putting into Operation
Note!
The vacuum chamber is soiled with oil.
If you switch off the machine during the packaging process by pressing
the main switch, e.g. in order to clean the machine with closed lid, it
might occur that oil from the vacuum pump enters into the chamber.

Do not switch off the machine by pressing the main switch during
the packaging process.

Unhook the gas spring in order to close the lid.
VAC STOP button

To set the evacuation time
(between 2 and 40 seconds, increment 1 second)
- press the VAC STOP button when the cover is open
change the evacuation time by pressing the
-

Abort the vacuum procedure, e.g. if liquids are boiling during
the vacuum procedure (vacuum stop):
- Press the VAC STOP button.
Note!
Boiling hazard.

When packaging liquid the evacuation time must be selected so
that the vacuum does not reach more than 95 % (vacuum gauge
display between 0 and -0.95).
Operating Instructions - Translation
or buttons
SEAL button

To set the sealing
increment 0.1 sec
press the SE
-
change the s
-
Important!
Limitation for sealing time

The maximum sealing t
of machine and cannot
GAS ON/OFF button
not used – machine h
Arrow buttons

Changing of the p

Pressing and hold
small increments
or