Operation - Komet NikiVac Notice D'utilisation

Operation

7 Operation
Danger!

Observe the valid accident prevention instructions!
Caution!
Combustion hazard!

Sealing pads and silicone rubber become hot during operation.
Wear protective gloves!
Note!

Regularly carry out the necessary servicing and maintenance work
(see chapter "Maintenance and Fault Repair").

Keep the vacuum chamber dry, which also applies underneath and
between the insertion plates.
Important!

Pressure-sensitive products can be damaged by the vacuum bag
during or after the packaging procedure.
Important!

The product being packaged must be dry and cold, it is only in this
way that a sufficient vacuum can be achieved. The power of the
pump is affected by the humidity of the product and the humidity on
the inside of the chamber.
Operating Instructions - Translation
Important!
Packaging liquids and moist

Remove the insertion pla

Place the filled vacuum b

When packaging liquids
setting, which is too high

For liquids (e.g. sauces)
at a core temperature of
vacuum.
If you note the formation of b

immediately press the V

set the evacuation time f
no more vaporisation occ
The boiling point (transition f
dropping the air pressure in
a result at an air pressure of
The resulting steam can be n
bubbles (aeration). Escaping
and creates corrosion there.
The effects of air pressure a
water can be seen in the foll
temperature of 36°C at an ai