Komet NikiVac Notice D'utilisation page 38

Installation and Putting into Operation
Display

Display of the currently saved parameter value

Display of the actual evacuation, gassing or sealing time

Display OO: Machine is in Standby

Display
During packaging cycle, when the machine is working
-
outside the set parameter values.
GAS ON/OFF has been pressed but the machine is
-
without a gassing functionality.

Display Er: Error, Machine is locked.
You can cancel the locking by switching the machine off and
by switching it on again.

Display OL: Check the oil level and quality.
You can acknowledge the oil check by pressing VAC STOP.

Display SE: Service program is active.
You can cancel the service program by pressing VAC STOP.
Operating Instructions - Translation
- -
Oil display
on the inspection glass on the pump.
Opening in the casing - right-hand side.
For checking the oil level and the oil quality for the
vacuum pump:
Oil level: must be between min and max.
Oil quality: Oil should be gold-yellow.
Important!

If the machine was in op
checking the oil (foam re

If the oil is not gold-yello
done.
Vacuum gauge

Display of the vac
Pneumatic spring for keeping the cha

The chamber cover is automatical
the packaging procedure by mean
Danger!

Under no circumstance
Pneumatic springs hav
approx. 300 bar).

Prior to disposal the pn
Please request our dis

The pneumatic springs
Do not grease or oil the