Squeegee Installation - Advance Adfinity 20D Instructions D'utilisation

Types of cylindrical brushes available and application guide (suggestions only)
Models
General cleaning:
Concrete
Terrazzo fl oor
Ceramic tiles/quarrystones
Marble
Vinyl tiles
Rubber tiles

Squeegee installation

1. Install the squeegee (25) and fasten it with the handwheels (26), then connect the vacuum hose (15) to the squeegee.
2. With the handwheel (27), adjust the squeegee so that the rear blade - in all its length - touches the fl oor and the front blade is
slightly detached from the fl oor.
Guide to match squeegees and brush/pad-holder decks
Deck model
Deck with one brush (18a), brush diameter: 20.9 in (530 mm)
Deck with two brushes (18b), brush diameter: 12.0 in (305 mm)
Deck with two cylindrical brushes (18c), brush length: 19.1 in (485 mm)
Solution or washing water tank fi lling
NOTE
For Adfi nity™ X20D, X20C, X24D: [switch (83 and 77) enabled] pour clean water in the tank.
For Adfi nity™ 20D: pour solution.
1. Open the fi ller neck (8).
2. (For Adfi nity™ 20D)
Fill the tank (20) with a solution suitable for the work to be carried out.
Do not fi ll the solution tank completely, leave few inches from the edge.
Always follow the dilution instructions on the label of the chemical product used to prepare the solution.
The solution temperature must not exceed +104 °F (+40 °C).
CAUTION!
Use only low-foam and non-fl ammable detergents, intended for automatic scrubber applications.
(For Adfi nity™ X20D, X20C, X24D)
Fill the tank (20) with clean water.
Do not fi ll the clean water tank completely, leave a few inches from the edge.
The water temperature must not exceed +104 °F (+40 °C).
Detergent tank fi lling (for Adfi nity™ X20D, X20C, X24D)
3. Open the cover (22) and check that the recovery water tank (21) is empty, otherwise empty it with the drain hose (16).
4. Grasp the handle (41) and carefully lift the tank (40).
5. Open the plug (46).
6. Fill the tank (45) with a detergent suitable for the work to be carried out (highly concentrated detergents).
Do not fi ll the detergent tank completely, leave a few inches from the edge.
CAUTION!
Use only low-foam and non-fl ammable detergents, intended for automatic scrubber applications.
NOTE
If the detergent hose (48) is empty (in case of new system, system emptied for cleaning, etc.), in order to fi ll the hose
quickly, it may be useful to drain the EcoFlex™ once or several times (see the procedure in the Maintenance chapter).
Adfi nity™ 20D - X20D - X20C - X24D
POLYPROPYLENE 0.40
INSTRUCTIONS FOR USE
HARD NYLON 0.60
Squeegee model
Aluminum (Fig. 7), width 29.9 in (760 mm)
Steel (Fig. 6), width 31.9 in (810 mm)
Aluminum (Fig. 7), width 29.9 in (760 mm)
9096910000(2)2010-03
ENGLISH
SOFT NYLON 0.45
15