Machine Start And Stop; Stopping The Machine; Machine Operation (Scrubbing/Drying) - Advance Adfinity 20D Instructions D'utilisation

ENGLISH

MACHINE START AND STOP

Starting the machine
1. Prepare the machine as shown in the previous paragraph.
2. Turn the ignition key (80) to "I" position.
Check that the green warning led (81a) turns on (charged batteries).
If the yellow or red warning led (81b or 81c) turns on, turn the ignition switch back to "0" position and charge the batteries (see
the procedure in the Maintenance chapter).
3. Drive the machine to the working area, by keeping the hands on the handlebar (2) and pressing the paddle (3) forward to move
forward, and backwards to move in reverse.
The maximum forward speed can be adjusted with the adjuster (4).
4. Lower the squeegee (25) with the lever (10).
5. Lower the brush/pad-holder deck by pressing the pedal (11).
6. Press the brush/pad-holder and vacuum system switch (71).
7. Press the washing detergent fl ow control switches (82) as necessary, depending on the type of cleaning to be carried out.
8. Start cleaning, by moving the machines as shown in step 3. If necessary, adjust the maximum speed with the adjuster (4).

Stopping the machine

1. Stop the machine by releasing the paddle (3).
2. Turn off the brushes/pad-holders and the vacuum system by pressing the switches (71) and (73).
3. Lift the brush/pad-holder deck by pressing the pedal (11).
4. Lift the squeegee (25) with the lever (10).
5. Make sure that the machine cannot move independently.

MACHINE OPERATION (SCRUBBING/DRYING)

1. Start the machine as shown in the previous paragraph.
2. If necessary, press the washing detergent fl ow control switches (82) as necessary, depending on the type of cleaning to be
carried out.
3. If necessary, stop the machine and adjust the squeegee balancing handwheel (27).
4. If necessary, stop the machine and turn the adjusting handwheel (28); when turning it clockwise or counter-clockwise the
machine forward speed can be adjusted.
NOTE
For correct scrubbing/drying of fl oors at the sides of the walls, Advance suggests to go near the walls with the right side
of the machine as shown in fi gure 4.
CAUTION!
To avoid any damage to the fl oor surface, turn off the brushes/pad-holders when the machine stops in one
place, especially when the extra pressure function is on.
16
INSTRUCTIONS FOR USE
A
9096910000(2)2010-03
Figure 4
Adfi nity™ 20D - X20D - X20C - X24D
B
P100300