Squeegee Installation - Advance SC500 Instructions D'utilisation

Brush or pad-holder removal/installation (REV™
system)
1. Make sure that the REV™ deck (37) is lifted.
2. Turn off the machine and remove the operator key (41).
3. According to the kind of cleaning to be performed, install
the pad (A, Fig. 3) or the brush (C, optional) and note the
following:
• Place the pad (A) under the deck and press it until it is
fastened with the Velcro of the drive disc (B).
• Place the brush (C, optional) under the deck, and then
match the centering pins (D) to the respective holes of
the drive disc (B), and then engage the brush with the
three mounting screws (E).
4. To remove the pad or brush, proceed in the reverse order.

Squeegee installation

1. Install the squeegee (A, Fig. 4) and fasten it to the bracket
(C) with the handwheels (B).
2. If necessary, adjust the squeegee with the knob (D) so that
the rear blade (E) and front blade (F) touch the floor as
shown in the figure.
Washing water tank filling
1. Ensure that the washing water valve (18) is open (18-A).
2. To fill the washing water tank (21) use the water removable
filler hose (23) or the front filler (22), or open the cap (24)
to access the side filler.
3. Fill the tank (21) with clean water.
Do not fill the tank completely, leave a few inches from the
edge. Use the level hose (13) as reference.
The water temperature must not exceed 40 °C.
11/14
INSTRUCTIONS FOR USE
C
D
Figure 3
F
Figure 4
9099980000 - SC500
ENGLISH
B
A
E
P100857
C
A
B
D
B
E
P100843
13