Advance Adfinity 20D Instructions D'utilisation page 19

Adjustment of the detergent concentration in the solution
(For Adfi nity™ X20D, X20C, X24D)
The system used to mix the detergent with the washing water can be activated by pressing the detergent fl ow control switch (A, Fig.
5): when the LED (B) is on, the detergent is added to the washing water.
The display (C) shows the detergent concentration level (1 to 6) in the solution: for the related percentage values refer to the table
(D).
NOTE
The detergent concentration in the solution dispensed from the system always corresponds to level 1.
In order to temporarily obtain a stronger concentration, press the EcoFlex™ switch or disable the EcoFlex™ system (see
the relevant paragraph).
EcoFlex™ switch
(For Adfi nity™ X20D, X20C, X24D)
Press the EcoFlex™ switch (E, Fig. 5) whenever a stronger washing power is required.
When you press the switch (E) (the led indicator (F) is fl ashing) the solution fl ow increases and the detergent concentration in the
corresponding solution rises to the set level (moreover, if the detergent mixing function is not activated, it is automatically activated).
The original settings can be restored by pressing the switch (E) once again (the led indicator (F) is ON).
NOTE
If the switch (E) is not pressed once again, the original settings are restored automatically after 60 seconds.
In order to change the actual detergent concentration, proceed as follows:
1. Turn off the detergent fl ow control switch (A) (the LED (B) must be OFF).
2. Press and hold the detergent fl ow control switch (A) until the LED (B) fl ashes.
3. Release the switch (A). Press it again shortly to go to the next level shown by the display (C); repeat the operation until the
desired setting is reached.
4. Wait until the LED (B) stops fl ashing: the new level is now set.
NOTE
Detergent percentage setting is stored into memory, even if the machine is turned off.
Adfi nity™ 20D - X20D - X20C - X24D
INSTRUCTIONS FOR USE
9096910000(2)2010-03
ENGLISH
17