Before Machine Start-Up - Advance Adfinity 20D Instructions D'utilisation

BEFORE MACHINE START-UP

Deck installation/removal
The machine can be equipped with either the brush/pad-holder deck (18a and 18b) or the cylindrical brush deck (18c).
For deck installation/removal see the procedure in the Maintenance chapter.
NOTE
When the deck is installed/removed, it may be necessary to change the squeegee too, because they must have the
same width. For correct matching of deck and squeegee, see the Squeegee Installation paragraph.
Brush/pad-holder installation/removal
1. According to the kind of cleaning to be carried out, the machine can be equipped either with brushes (A, Fig. 2) or pad-holders
(B) with pads (C) together with the appropriate deck.
2. Turn the ignition key (80) to "0" position.
If equipped, turn the speed adjuster (4) to idle by turning it counter-clockwise.
3. Place the brushes (A) or the pad-holders (B) under the appropriate deck (18a) or (18b).
4. Lower the deck on the brushes/pad-holders by pressing the pedal (11).
5. Turn the ignition key (80) to "I" position.
6. Press the brush/pad-holder and vacuum system switch (71).
7. Slightly press the paddle (3) forward to engage the brushes/pad-holders, then release it. If necessary, repeat the procedure
until the brushes/pad-holders are engaged.
WARNING!
Do not press the paddle (3) completely, otherwise the machine will start.
A light pressure on the paddle (3) is enough to engage the brushes/pad-holders and activate the brush/pad-
holder motors.
8. To remove the brushes/pad-holders, the deck must be lifted by pressing the pedal (11), then press the switch (75) and wait for
the brushes/pad-holders to fall on the fl oor.
Turn the ignition key (80) to "0" position.
Adfi nity™ 20D - X20D - X20C - X24D
INSTRUCTIONS FOR USE
Figure 2
9096910000(2)2010-03
ENGLISH
S311317
13