Before Machine Start-Up - Advance SC450 9087331020 Instructions D'utilisation

BEFORE MACHINE START-UP

Brush or pad-holder installation
NOTE
Install either the brush (A, Fig. 3) or the pad-holder (B and C) according to the type of floor to be cleaned.
1. Make sure that the switches (41 and 42) are turned to "0".
2. Lift the brush/pad-holder deck (13) by prying the handlebar (2).
3. Place the brush (A, Fig. 3) or the pad-holder (B - C) under the deck.
4. Lower the deck (13) by using the handlebar (2).
5. Turn on the machine by pressing the switch (41).
6. Press the push-button (47) for a few seconds, to engage the brush/pad-holder to the deck hub (13). If necessary, repeat the
procedure until the brush/pad-holder is engaged.
A
Available brushes and their relevant application guides (suggestions only)
Models
General cleaning:
Concrete
Terrazzo floor
Ceramic tiles/quarrystones
Marble
Vinyl tiles
Rubber tiles
Polishing:
Rubber tiles
Marble
Vinyl tiles
Squeegee installation
7. Install the squeegee (21) and fasten it with the handwheels (22), then connect the vacuum hose (10) to the squeegee.
8. With the handwheel (23), adjust the squeegee so that the rear blade - in all its length - touches the floor and the front blade is
slightly detached from the floor.
8/12
Front
Figure 3
MIDLITE GRIT 180 MIDGRIT 240
INSTRUCTION FOR USE
B
C
PROLENE
9099602000 - SC450
ENGLISH
P100663
PROLITE UNION MIX
13