Use; Before Machine Start-Up - Advance Micromatic M17E Instructions D'utilisation

ENGLISH

USE

WARNING!
On some points of the machine there are some adhesive plates indicating:
– DANGER
– WARNING
– CAUTION
– CONSULTATION
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates.
Do not cover these plates for any reason, in case of damage replace them immediately.

BEFORE MACHINE START-UP

Brush or pad-holder installation
NOTE
Use either the brush (42) or the pad-holder (43) according to the type of fl oor to be cleaned.
1. Insert the positioning pin (24) and deactivate the transport/parking device (23b).
2. Lift the brush/pad cover (10) by prying the handlebar (2).
3. Place the brush (42) or the pad-holder (43) under the deck.
4. Lower the deck (10,) by means of the handlebar (2).
5. Connect the power supply cable (21) to the electrical mains.
6. Engage the brush/pad-holder by pressing the brush/pad switch (52) for a few seconds.
If the procedure is diffi cult, manually turn the brush/pad-holder counter-clockwise (45).
Brush/pad application guide (suggestions only)
Types of brushes available
Concrete
Terrazzo fl oor
Ceramic tiles/quarrystones
General cleaning
Marble
Vinyl tiles
Rubber tiles
Rubber tiles
Polishing Marble
Vinyl tiles
Squeegee installation
7. Install the squeegee (11) and fasten it with the handwheels (12), then connect the vacuum hose (22) to the squeegee.
Solution tank fi lling
8. Use the fi ller neck (35) to fi ll the tank (27) with a solution suitable for the work to be performed.
Do not fi ll the solution tank completely, leave few inches from the edge.
Always follow the dilution instructions on the label of the chemical product used to prepare the solution.
The solution temperature must not exceed 40°C.
CAUTION!
Use only low-foam and non-fl ammable detergents, intended for automatic scrubber applications.
Adjustments
9. Using the knob (3), adjust the handlebar (2) to the most comfortable position.
12
INSTRUCTIONS FOR USE
909 5855 000(4)2009-11
Midlite Grit 180 Midgrit 240
Micromatic™ M17E
Prolite Union Mix