Operating The Machine; Before Starting The Machine; Starting The Diesel Engine; Starting The Gasoline / Petrol Engine - Advance SW8000 Mode D'emploi

OPERATING THE MACHINE

The SW8000 is a rider-type automatic fl oor sweeping machine. The controls were designed with one touch operation in mind. For single pass
sweeping the operator can simply lower the main broom and all sweeping functions will be ready to go.
Note: Bold numbers in parentheses indicate an item illustrated on pages 6-9.

BEFORE STARTING THE MACHINE

1 Be sure you understand all machine controls and their functions.
2 Plan your cleaning route. Arrange long, straight passes with as few turns as possible.
3 Check the Brake Pedal (FF). The pedal should be fi rm.
If the pedal is "spongy" or fades under pressure, DO NOT DRIVE THE MACHINE. Report all defects immediately to service personnel.

STARTING THE DIESEL ENGINE

1 Turn the Key Switch (TT) counter-clockwise to the "Pre-Heat" position and hold it there until the Glow Plug Indicator (FF) turns OFF. Once
the indicator turns OFF the engine can be started. Skip this step if the engine has been running and is already warm.
2 Turn the Key Ignition Switch (TT) clockwise to the START position and release it as soon as the engine starts. If the engine does not start
after cranking for 15 seconds, release the key, wait for 1 minute and try steps 1-3 again.
NOTE: The engine starter will not engage if the FWD / REV Drive Pedal (G) is not in the neutral position.
3 Let the engine run at "IDLE" speed for 5 minutes before using the machine.
4 Push the Engine Speed Switch (GG) to switch to "FULL THROTTLE" and move the machine around for 2 or 3 minutes at a slow speed to
warm up the hydraulic system.
STARTING THE LPG & GASOLINE / PETROL ENGINE
1 NOTE: LPG models only: Open the service valve on the LP fuel tank (21).
2 Turn the Ignition Key Switch (TT) clockwise to the START position and release it as soon as the engine starts. If the engine does not start
after cranking for 15 seconds, release the key, wait for 1 minute, then try again.
NOTE: The engine starter will not engage if the FWD / REV Drive Pedal (G) is not in the neutral position.
3 Let the engine run at "IDLE" speed for 5 minutes before using the machine.
4 Push the Engine Speed Switch (GG) to switch to "FULL THROTTLE" and move the machine around for 2 or 3 minutes at a slow speed to
warm up the hydraulic system.
NOTE: ALWAYS operate the machine with the Engine Speed Switch (GG) at full throttle. Use the FWD / REV Drive Pedal (G) - not the
Engine Speed Switch (GG) - to control the speed of the machine. The speed of the machine will increase as the pedal is pushed closer to the
fl oor.
ENGLISH / A-11
FORM NO. 56091065 - SW8000 - A-11