Set Zoom, Adjust Image Until It Is Sharp - Sygonix 12133D1 Notice D'emploi

Important!
If you want to choose another operating mode, you need to interrupt the power supply for a few seconds for
reasons of safety and then reconnect it.
Then proceed as described above to switch the operating mode again.

9. Set Zoom, Adjust Image until it is Sharp

The camera has a manually adjustable zoom lens; sharpening of the image is still possible.
At the front of the camera (on the left and on the right of the lens) there are two recessed screws for this that can be
adjusted with the enclosed small screwdriver. Do not use any force when twisting!
The desired zoom area can be set with the "ZOOM" screw. The picture can be brought into focus with the "FOCUS"
screw.
Observe:
It may be impossible to focus picture with the "FOCUS" screw in the two end positions of the "ZOOM" screw
(left or right stop) for constructional reasons.
In this case, turn the "ZOOM" screw back a little and then focus the picture.
33