Installation - Sygonix 12133D1 Notice D'emploi

6. Installation

• Mark the corresponding positions through the three attachment holes of the mounting ring if you need to drill any
holes to attach the mounting ring.
You must drill a sufficiently sized hole as well to pass through the connection cable for invisible and sabotage-proof
placement.
When drilling or tightening screws, ensure that no wires or lines are damaged.
Select the assembly site so that it is protected from manipulation attempts at the surveillance camera. The
surveillance camera therefore should be installed at a minimum height of 2.5 m.
• Either guide out the connection cable from the side of the mounting ring or push it through a present hole in the wall
where you want to screw on the mounting ring.
Protect the plugs from dust and dirt, e.g. with a small plastic bag.
If the connection cable is too short (depending on the wall thickness or mounting position), you need to use
a suitable connection box. This connection box must be suitable for assembly in the outdoor area depending
on assembly site of the camera.
The cable connection for the video output or the power supply can then be placed in the connection box; this
also applies to the housing with the control lever in the surveillance camera cable.
Place the cables so that they are protected from manipulation, e.g. in a cable duct or similar.
• Attach the surveillance camera to the desired position with three suitable screws (and, if required, dowels).
29