Air Discharge And Intake; Access To The Filters - SystemAir CONDENSATION PAR AIR 2450 Manuel D'installation Et De Maintenance

Before final installation of the unit mount the accessories (heater, rear or side air intake, plenum etc...). See the
specific document supplied with each accessory.
Remove the upper front panel, air intake panel and lower front panel
according to the instructions.
² REMOVAL OF UPPER FRONT PANEL A
(Access to the fan and the electrical heating or hot water
battery (accessory))
Unscrew the two screws, pull out downward.
² REMOVAL OF FRONT AIR INTAKE B
Turn the two fasteners by a quarter turn, pull out and up.
² REMOVAL OF LOWER FRONT PANEL C
(Access to refrigerant, hydraulic and electrical
connections)
Unscrew the two screws, pull out and up.

AIR DISCHARGE AND INTAKE

1. Direct air intake through the removable front panel A and the filter D (factory mounted).
2. Total rear air intake with duct:
Duct E to be mounted on the rear of the unit connection elements (remove the panel J).
3. Direct air discharge through plenum F with ajustable grilles (accessory) which are mounted on the
unit.
4. Air dischage through ducts:
Connection elements for air discharge ducts G (accessory) to be mounted on the top of the unit.
5. Possibility of partial fresh air intake, on side or rear with the accessory air intake duct H.
A
E
D

Access to the filters

1. Take off the air intake panels.
2. The filters D are maintained :
² in the fixed supports K, situated in the lower part of the evaparator M
² by the detachable supports L situated in the upper part the evaporator
3. To take them off :
² 1 Lift and
² 2 Pull.
2
1
6
F
G
J
10
A
3 3
4
B B
3 3
5
4 4 4
5
C C
6
H
M
K
2
1
1
2
L
D