Description - SystemAir CONDENSATION PAR AIR 2450 Manuel D'installation Et De Maintenance

DESCRIPTION

Access panel to ventilator
motor unit and the electric
heating or hot water battery
(accessory)
Controls and regulation
Removable front air intake
panel
Access panel to connections
(refrigerant, water, power
supply)
1. Pipe links to main unit (air cooled)
Cooling water supply (water cooled)
² Waste water outlet = 2450 nut 1" ( Ø 26- 34 )
² Recycled water outlet = 2450 1" 1/4 ( Ø 33 - 42 )
² Water supply 3250 nut 1" ( Ø 26 - 34 )
² Water supply 3250 nut 1" 1/2 ( Ø 40 - 49 )
2. Pipe links to main unit (air cooled)
Cooling water supply (water cooled)
² Waste water supply = 2450 nut 1" ( Ø 26- 34 )
² Recycled water supply = 2450 1" 1/4 ( Ø 33 - 42 )
² Water outlet 3250 nut 1" ( Ø 26 - 34 )
² Water outlet 3250 nut 1" 1/2 ( Ø 40 - 49 )
3. Condensate water evacuation – souple tube Ø
26x32
4. Electric connection - with "Faults report"
5. Electric connection - with "Remote control"
6. General electric supply
7. Electric connections to Outdoor unit - air cooled
8. Incorporated hot water battery inlet and outlet (M. Ø
33x42)
9. Safety evacuation at the base of unit
10. Packaging fixing holes (2 front - 2 rear). To be stopped
up with the unit fixing bolts on its pallet
11. Hole Ø 200 for possible connection of a new air inlet duct (to be carrier by the installer)
12. Rings situated at the 4 corners of the cabinet for vertical lifting (bar system).
13. Orifice Diameter 29 mm for vapour rod (not supplied), to be mandatorily installed on the right-hand
side of the appliance.
12
10
8
Air discharge
operings
12
8
13
11
A
9
A
4
5
7
6
2
3
1