Mounting The Flow-Switch (Optional, Apart From The Ls 300); Mounting The Control Panel - BWT PRO A Notice D'installation Et Conseils D'utilisation

4.1.5 Mounting the flow-switch (optional, apart from the LS 300)
Mount the saddle clamp that will house the flow-switch on a section of the cell by-pass loop between the
two shut-off valves. In the event that the flow-switch is mounted on a horizontal section of the pipe, the feed
head must be oriented upwards, and not downwards (impurities could accumulate in the mechanism and
prevent its correct operation). Connect the two flow-switch wires to the locations provided on the control
panel motherboard.
See chapter 4.3, Wiring
Respect the direction of flow (arrow) through the flow detector.
Upon completion of the hydraulic installation of the various components, fill the circuit with water and check
for leaks.
4.2

Mounting the control panel

Panel mounting accessories: once installed this method of mounting the panel will allow the panel to be
hung on and taken off the wall without any need for screws.
Select a location on a solid flat wall of the plant housing, high enough to be out of the reach of children.
Drilling template
Bushing
Rubber hinge Rubber stopper for hinges
x2
x2
x2 x2
Eye fastening screw
Suspension eye
Wall mounting screw
x4
x4
x4
Fasten the eyes to the back of the panel, horizontally and oriented towards the exterior of the panel. The
larger part of the aperture should be facing down.
38/88
2021/03 - Indice de révision : B Code : 29740 TRAITEMENT DE L'EAU