TOOLCRAFT LDM100H Mode D'emploi page 53

• Switch the device to "Continuous measurement" with the
(4) button. A first measured value is recorded and dis-
played as actual value (in the display area 12).
• Move the laser measuring point over the entire object.
The measurement does not need to be triggered
via the
When the device recognises a lower minimum or
a larger maximum value, a precise measurement
is triggered. The lowest value from the current
measurements is displayed under MIN (in the
display area 10), the highest one under MAX (in
the display area 11).
The device may trigger additional measurements.
These are displayed as actual values, but do not
change the minimum and maximum values when
they are in the interval between these.
For a very precise measurement, limit the de-
grees of freedom of movement of the device
during measurement. To only turn the device
around one axis, you can, e.g., support it on a
level surface. The distance from the column to be
measured is the minimum value.
Example
A tube depth can be measured the same way as described
above.
• Move from one inner tube wall to the opposite inner tube
wall in the middle. The total depth is displayed as the
maximum value.
(1) - MEAS button.
53