Switching Between Modes; Harness To Booster Mode - Britax Frontier XT Guide D'utilisation

Switching Between Modes

This seat may only be used in booster mode with children who
stand 106.7 – 165.1 cm (42 – 65 in.) in height and weigh more than
18.2 kg (40 lbs). Britax recommends booster mode only after the
child outgrows harness mode.

Harness to Booster Mode

To remove the harness and buckle:
Loosen the harness.
1
a Press release lever
b Pull both harness straps forward
Remove the belt shield and
2
unhook the harness straps from
the yoke.
Replace the belt shield (a) then
3
store the yoke in the slot (b).
46
Pull the harness straps out of
4
the slots.
* DO NOT remove the HUGS™
chest pads or chest clip.
On the bottom of the seat,
5
slide the retainer of one
harness strap up and pull it
away from the child seat shell.
Turn and slide the retainer
6
through the slot to remove.
* Pull the harness webbing tight
from the other side before
pulling the retainer through.
Repeat steps 5 and 6 for the
remaining harness buckle strap.
Remove the locking screw
7
from the head restraint
adjuster and insert into the
shell to store.
IMPORTANT: Store the screw in
the slot provided in the shell. Store
all parts of the harness in a safe
place. These parts will be needed
to convert the child seat back to
harness mode.
Switching Between Modes
Locking
Screw storage
47