Switching Between Modes; Harness To Booster Mode: Storing The Harness And Buckle - Britax FRONTIER CT Guide D'utilisation

Child Seat Functions
Energy-Absorbing Versa-Tether
The Versa-Tether can indicate when the child seat has been in a
moderate or severe crash and replacement of the child seat is
necessary.
Figure 1 shows the tether when
the child seat is acceptable for
continued use (provided the child
seat has not been involved in a
crash). The colored stitching will
be intact and the webbing will be
held under a tether label.
Figures 2 and 3 show examples
of when the child seat is
unacceptable for continued use.
If the tether label is torn, or if one
or both of the loops have pulled
through the back side of the shell
and/or any of the colored stitching
has ripped, the child seat is no
longer acceptable for use.
IMPORTANT: Discontinue use of
child seat if it has been involved
in a moderate or severe crash,
regardless of whether the loops
have pulled through the back
side of the shell and the colored
stitching has been ripped.
28
All manuals and user guides at all-guides.com
1
2
3
Before you begin:
IMPORTANT: It is not necessary to remove the harness to use this
seat in booster mode. To store the harness, follow the instructions
below. If you wish to remove, follow the instructions on pg. 32.

Harness to Booster Mode: Storing the Harness and Buckle

Loosen the harness
1
completely.
a Press release lever
b Pull both harness straps forward
Open the chest clip.
2
a Press tabs
b Pull apart
Release the harness buckle
3
and place the harness straps
around the armrests.
Open the CLICKTIGHT.
4
* Locate the two slots in the
CLICKTIGHT cover.
* Squeeze the CLICKTIGHT
.
release levers
Unhook the retaining clips at
5
the back of the seat cover. Pull
the seat cover forward and
slide over the EZ- Buckle belly
pad.

Switching Between Modes

29