Britax Frontier XT Guide D'utilisation page 17

Installing the Child Seat: Harness Mode
Locate the LUAS anchors in
1
your vehicle.
* Ensure harness height is
adjusted to fit your child.
Rotate the positioning block to
2
the front and place the child
seat on the vehicle seat.
Verify that the LCS strap is not
3
twisted and firmly press the
LCS connectors onto their
adjacent LUAS anchors to
attach.
Push the child seat into the
4
vehicle seat and pull the end
of the LCS strap through the
belt slot to secure.
* The child seat is secure when it
cannot be moved front-to-back
or side-to-side more than 2.5
cm (1 in.) at the belt path. If the
child seat is not secure, repeat
the installation procedure or
use a different seating location.
Firmly press the Versa-Tether
5
hook to the vehicle tether
anchor to attach. Remove all
slack from the tether webbing.
Use the elastic strap to contain
6
extra webbing.
30
1
®
OR
OR
Check Versa-Tether
(Top Tether) attachment
2
Check that there is
LESS than 2.5 cm (1 in.)
of movement (front to back
or side to side) at the belt path
connector attachments
Checklist
Check that positioning block is rotated to the front.
9
9 Check all connections and verify that child seat is secure.
* The child seat is secure when it cannot be moved front-to-
back or side-to-side more than 2.5 cm (1 in.) at the belt path.
If the child seat is not secure, repeat the installation procedure
or use a different seating location.
Ensure any excess Versa-Tether
9
band. Always ensure any excess webbing is contained within
your vehicle.
Installing the Child Seat: Harness Mode
®
< 2.5 cm.
Check that the
Check LCS
Positioning Block is
rotated to the front
webbing is stored in elastic
®
Check that Versa-Tether ®
(Top Tether) webbing is
stored in elastic band
31