Britax Frontier XT Guide D'utilisation page 20

Installing the Child Seat: Harness Mode
Rotate the positioning block to
1
the front and place the child
seat on the vehicle seat.
* Ensure harness height is
adjusted to fit your child.
Pull the vehicle seat belt out and
2
route the belt through the first
belt slot, under the cover and
through the second belt slot.
Verify that the belt is not
3
twisted and then buckle.
Push the child seat firmly
4
into the vehicle seat while
removing all slack from the lap
part (a), then shoulder part (b)
of the vehicle seat belt.
* Ensure that the vehicle seat belt
is locked as directed by your
vehicle owner's manual.
* The child seat is secure when it
cannot be moved front-to-back
or side-to-side more than 2.5
cm (1 in.) at the belt path. If the
child seat is not secure, repeat
the installation procedure or
use a different seating location.
Firmly press the Versa-Tether
5
hook to the vehicle tether
anchor to attach. Remove all
slack from the tether webbing.
Use the elastic strap to contain
6
extra webbing.
36
®
OR
OR
Installing the Child Seat: Harness Mode
Check Versa-Tether ®
(Top Tether) attachment
Check that there is
LESS than 2.5 cm (1 in.)
of movement (front to back <2.5 cm
or side to side) at the belt path
Check vehicle
buckle attachment
Checklist
Check that positioning block is rotated to the front.
9
9 Check all connections and verify that child seat is secure.
* The child seat is secure when it cannot be moved front-to-
back or side-to-side more than 2.5 cm (1 in.) at the belt path.
If the child seat is not secure, repeat the installation procedure
or use a different seating location.
Ensure any excess Versa-Tether
9
band. Always ensure any excess webbing is contained within
your vehicle.
Check that Versa-Tether
(Top Tether) webbing is
stored in elastic band
Check that the
Positioning Block is
rotated to the front
webbing is stored in elastic
®
37
®