Britax Frontier XT Guide D'utilisation page 8

Vehicle Compatibility
4.
ELR (Emergency Locking Retractor) with a Sliding Latch Plate
Has a latch plate that freely
a
slides along the vehicle
seat belt webbing.
Has a retractor that locks
b
only in an emergency
situation such as sudden
stop or crash.
IMPORTANT: This belt type requires
the use of a locking clip to secure
the seat during installation. A locking
clip must be secured approximately
2.5 cm (1 in.) from the latch plate to
secure the child seat.
Call Britax Consumer Services at
1(888) 427-4829 to obtain a locking
clip.
Lap Belt
IMPORTANT: A Lap belt may only be used to install the child seat
in harness mode and should never be used to secure your child in
booster mode.
5.
ALR (Automatic Locking
Retractor)
Has a latch plate that is
a
sewn into the webbing.
12
b
c
2.5 cm (1 in.)
from Latch
Plate
6.
Locking Latch Plate
a
b
Latch
Plate
Has a retractor that stops the
belt from being pulled out
again once the belt webbing
has been pulled out at least
61 cm (24 in.).
Tightens by feeding the
belt webbing back into the
retractor.
Has a latch plate that
does not allow the belt to
become loose after it is
buckled.
Tightens by pulling on the
belt webbing.
Vehicle Compatibility
Latch
Plate
Adjuster
13