Adding Remote Controls; Operating Diagnostics - SOMFY ROLLIXO RTS Manuel D'utilisation

Rollixo RTS

4.3 Adding remote controls

This operation must be carried out close to the receiver.
This operation involves adding a remote control to your installation by copying
a remote control already used on your installation.
Remote control "A" = "source" remote control already memorised
Remote control "B" = "target" remote control to be added
> 2 or 4-button remote control
A
[1]. Press the outer left and right buttons on the previously memorised remote
[2]. Press the remote control button A which controls your roller garage door
for two seconds.
[3]. Press the button on new remote control B which will control your roller
garage door.
> 3-button remote control
A
2s

5 - OPERATING DIAGNOSTICS

The indicator lights on the front of the Rollixo receiver notify the user of the
installation's status.
Safety edge
Motor
Fall protection
1
Indicator light status Meaning
Off Functional installation
Deactivation/activation in progress
Permanently lit Installation fault/failure
Diagnostics
Motor
Consequences
Actions
4
A
B
2s
B
< 1s
Safety edge
transmitter batteries
Photoelectric
cells
2 3 4
Indicator light status
Activated motor thermal protection
No movement possible
Wait around 10 minutes.
Diagnostics
Consequences
Actions
Radio safety
edge
Diagnostics
Consequences
Actions
Diagnostics
Consequences
Actions
Diagnostics
Consequences
Actions
Photoelectric
cells
Diagnostics
Consequences
Actions
If a fault is still present on your installation, please contact your installer.
Prog
Indicator light status
Radio interference on the safety edge
transmitter
Opening and stopping ok
Closing by pressing and holding down
the button within sight of the door
If a powerful radio system is present on
the site (infrared detector, TV transmitter,
etc.) and is transmitting on the same
frequency, the receiver will wait for the
transmission to end to before controlling
the door again.
Safety edge transmitter low battery
indication.
Opening ok
Closing by pressing and holding down
the button within sight of the door
If the fault persists, replace the safety
edge transmitter batteries.
Obstacle detection
Remove the obstacle by automatic partial
opening
Check that no obstacle is causing the
safety edge to detect.
Cell fault
Opening ok
Closing by pressing and holding down
the button within sight of the door
Check that no obstacle is cutting across
the cell beam
Obstacle detection
Remove the obstacle by full automatic
opening
Check that no obstacle is cutting across
the cell beam.
Copyright © 2014 SOMFY ACTIVITES SA. All rights reserved.
Prog