Adding Remote Controls; Operating Diagnostics - SOMFY ROLLIXO io Manuel D'utilisation

Rollixo io

4.3 adding remote controls

This operation must be carried out close to the receiver.
This operation is used to copy the function of a button on a memorised Keygo
io remote control to a button on a new Keygo io remote control.
[1]. Press the outer left and right buttons on the previously memorised remote
control simultaneously until the green indicator light flashes.
[2]. Press the button to be copied on the remote control already memorised
until the indicator light on top of the
permanently.
[3]. Briefly press the outer left and right buttons on the new remote control
together.
[4]. Briefly press the selected button to actuate the motorisation on the new
remote control.
The indicator light above the
remote control is stored in the receiver.
[1] [2]
[3] [4]

5 - oPeratinG DiaGnostiCs

The indicator lights on the front of the Rollixo receiver notify the user of the
installation's status.
safety edge
fall protection
motor
1
STOP
indicator light status meaning
Off Functional installation
Rapid flashing Deactivation/activation in progress
Permanently lit Installation fault/failure
Diagnostics
motor
Consequences
Actions
Copyright © 2014 Somfy SAS. All rights reserved.
button on the receiver comes on
Prog
button on the receiver flashes; the
Prog
remote control
memorised
Prog
remote control to be
memorised
Prog
safety edge
transmitter batteries
Photoelectric
cells
2 3 4
Prog
indicator light status
Activated motor thermal protection
No movement possible
Wait around 10 minutes.
Diagnostics
Consequences
Actions
radio safety
edge
Diagnostics
Consequences
Actions
Diagnostics
Consequences
Actions
Diagnostics
Consequences
Actions
Photoelectric
cells
Diagnostics
Consequences
Actions
If a fault is still present on your installation, please contact your installer.
Prog
indicator light status
Radio interference on the safety edge
transmitter
Opening and stopping ok
Closing by pressing and holding down
the button within sight of the door
If a powerful radio system is present on
the site (infrared detector, TV transmitter,
etc.) and is transmitting on the same
frequency, the receiver will wait for the
transmission to end to before controlling
the door again.
Safety edge transmitter low battery
indication.
Opening ok
Closing by pressing and holding down
the button within sight of the door
If the fault persists, replace the safety
edge transmitter batteries.
Obstacle detection
Remove the obstacle by automatic partial
opening
Check that no obstacle is causing the
safety edge to detect.
Cell fault
Opening ok
Closing by pressing and holding down
the button within sight of the door
Check that no obstacle is cutting across
the cell beam
Obstacle detection
Remove the obstacle by full automatic
opening
Check that no obstacle is cutting across
the cell beam.
Prog
4