Adding Remote Controls - SOMFY ROLLIXO io Manuel D'utilisation

Rollixo io
operation in automatic closure mode
Automatic closure of the door occurs after a time delay programmed during installation.
A new command during this time delay cancels automatic closing and the door remains open.
The following command results in the closure of the door.

adding remote controls

This operation must be carried out close to the receiver.
This operation is used to copy the function of a button on a memorised Keygo io remote control (remote
control "A") to a button on a new Keygo io remote control (remote control "B").
[1] [2]
remote control memorised
[1]. Press the outer left and right buttons on the previously memorised remote control simultaneously until
the green indicator light flashes.
[2]. Press the button to be copied on the remote control already memorised until the indicator light on top
of the button on the receiver comes on permanently.
Prog
[3]. Briefly press the outer left and right buttons on the new remote control together.
[4]. Briefly press the selected button to actuate the motorisation on the new remote control.
The indicator light above the
receiver.
Copyright © 2012 Somfy SAS. All rights reserved
[3]
Prog
remote control to be memorised
button on the receiver flashes; the remote control is stored in the
Prog
[4]
Prog
5