Inserting And Connecting The Receiver Battery; Removing The Cabin Hood - Reely DLG 650 RC Notice D'emploi

12. Inserting and connecting the receiver battery

a) Removing the cabin hood
To use the receiver battery in the model, the cabin hood (1)
must be removed. To do this, press the locking tabs (2) on
the right and left so that the two catches (3) are no longer
in the recesses on the fuselage.
Then lift the hood slightly at the rear edge and pull the hood
off backwards in the direction of the tail unit.
To replace the hood again later, first guide out the retaining
pin (4) on the front edge of the cabin hood under the fuse-
lage shell and then position the cabin hood so that the two
catches snap into the fuselage recesses again.
Figure 6
40