Reely DLG 650 RC Notice D'emploi page 45

Rudder function (mode 1 and 2)
If the joystick for the rudder function (see figure 1, no. 4) is moved to the left, the rudder should swing to the left. The
rear rudder edge should be deflected to the left by approx. 15 mm. In flight, the tail unit is pushed to the right and the
model curves to the left.
If the joystick for the rudder function (see figure 1, no. 4) is moved to the right, the rudder should swing to the right.
The rear rudder edge should be deflected to the right by approx. 15 mm. In flight, the landing gear is then pushed to
the left and the model curves to the right.
If the rudders do not deflect as described above, the direction of the servo needs to be changed using the
DIP switch on the transmitter. For further information on this aspect, refer to the following section: "Setting
the DIP switches".
Figure 15
Figure 16
45