Final Assembly Of The Model Plane - Reely DLG 650 RC Notice D'emploi

11. Final assembly of the model plane

Attach the wings (1) to the top of the fuselage as shown in
the adjacent picture and fasten the wings in place with the
two enclosed plastic screws (2).
Ensure that the wing is aligned at an angle of exactly 90°
to the fuselage. The two distances "A" must be the same
length.
If you look at the model glider from behind from a distance
(see lower image in figure 5), the tail unit must be at an
angle of 90° and the wing tips the same distance (B) from
the elevator line.
Practical tips
Any tilting of the wings can be easily corrected by taking
the wing off again and building up the fuselage slightly with
some adhesive tape on the side where the wing is too low.
Figure 5
39