Self-Cleaning Function; Storage - Cleanmaxx TK-7271 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Empty the water reservoir (see the "After Use" section).
If necessary, wipe off the outside of the device with a soft, slightly damp cloth and dry
it with a soft cloth.

Self-Cleaning Function

If you do not use distilled water, perform the working steps which are described below
regularly (at least every 10 operating hours):
1. Move the steam quantity control to
the plug out of the plug socket.
2. Fill the water reservoir around half full with water (see the "Filling the Water Reser-
voir" section). Ideally you should only ever use distilled water for self-cleaning.
3. Place the device upright on a stable, fl at and heat-resistant surface.
4. Plug the mains plug into a properly installed, easily accessible mains socket and
move the temperature control to position MAX.
5. Wait until the device has heated up and the temperature control lamp goes out.
6. Move the temperature control to position min.
7. Remove the mains plug from the mains socket.
8. Hold the device horizontally over a sink or similar outlet.
9. Press the Self Clean button (5).
10. Allow the water reservoir to run completely empty. Tilt the device back and forth
slightly to allow the water to run out of all nozzles.
11. If necessary, repeat the cleaning process several times until no more limescale resi-
dues emerge from the nozzles.
12. After the device has cooled down completely, pull the steam quantity control unit
out and turn the device upside down in order to remove any remaining amounts of
limescale or water.
Separate descaling of the device is not necessary.

Storage

Before you store away the device, allow it to cool down completely and clean it in the
manner described in the "Cleaning and Care" chapter.
Store the device in a dry, clean, frost-free location which is out of the reach of chil-
dren. When you do this, place the device upright on its base on a fl at, stable surface.
08951_DE-GB-FR-NL_V1.indb 25
08951_DE-GB-FR-NL_V1.indb 25
, move the temperature control to min and pull
25
07.08.2014 14:38:17
07.08.2014 14:38:17

Publicité

Table des Matières
loading

Table des Matières