System Setup; Monitor - Spektrum DX8G2 Manuel D'utilisation

FUNCTION LIST

System Setup

Use System Setup to enter the System List from the Function list
without turning the transmitter off. A Caution screen will appear
that warns that RF will be disabled (the transmitter will no longer
transmit). Press YES if you are sure and want to access the System
List. If you are not sure, press NO to exit to the main screen and
continue operation.
If you do not press YES or NO, the system will exit to the main
screen and continue operation within approximately 10 seconds.

Monitor

The Monitor screen displays the servo positions for each channel
graphically and numerically. This is useful to verify programming
functions, trim settings, mix directions, etc. The numeric value is
directly relative to the travel adjust and mix values (e.g., 100%
travel adjust equals 100% value in the Monitor).
SPEKTRUM DX8G2 • TRANSMITTER INSTRUCTION MANUAL
WARNING: Do not press YES unless the model is turned
off or the model is secured.
EN
37