6.3 Adjusting the Position of the Extraction Nozzle
The extraction arm, and the extraction nozzle are designed so as to be easily
manually adjusted and additionally brought closer. At the same time, the extraction
nozzle is held in the set position automatically. Furthermore, both the extraction
nozzle and the extraction arm rotate by 360 degrees so they can be adjusted to
almost any position. To provide for a sufficient suction of welding fumes it is
important that the extraction nozzle is always in the correct position. The correct
position is shown in the following picture.
Picture 11, Adjusting the position of the extraction nozzle
Adjust the position of the extraction arm so that the extraction nozzle is located at
●
an angle above the point of welding.
The extraction nozzle must be set so that with regard to the thermally conditioned
●
movement of welding fumes and suction reach it safely sucks all welding fumes.
Place the extraction nozzle always sufficiently close the relevant welding point.
●
CAUTION
Incorrect placement of extraction nozzle or insufficient suction power does
not ensure sufficient suction of air containing hazardous substances with
extraction nozzle. Hazardous substances can thus reach the user's
airways and lead to injury!
Order No.: 150 0004
Technical changes and errors reserved.
KEMPER Welding Fumes Stationary Filter
- 69 -
Instruction Manual - EN
rev.:
0
Status as of: 04/2014