Installation; Filtration Unit Unpacking And Inspection; Conditions For Installation - Kemper 150 0004 Mode D'emploi

5 Installation

5.1 Filtration Unit Unpacking and Inspection

• Remove packing materials carefully.
• Check completeness of the delivery. Use the delivery note for this check.
• If any parts are missing or supplied incorrectly, contact Kemper GmbH or the
forwarder immediately.

5.2 Conditions for Installation

CAUTION
Risk of injury resulting from falling components!
Insufficiently mounted components may be released and
cause you severe injury!
● Use only suitable mounting material for wall installation
● Install the welding fumes filter only on the walls and columns
suitable for such purpose
● Observe tightening torques of screws
● Use only the delivered installation material and suitable
mounting material
DANGER
There can be injuries hazardous for life as a result of falling
components.
The welding fumes filter and its components may fall down
and cause you fatal injury as a result of unprofessional
mounting.
● Install the welding fumes filter only on the walls and
columns with sufficient load bearing capacity.
● Make sure that the column is firmly anchored to the floor.
Order No.: 150 0004
Technical changes and errors reserved.
KEMPER Welding Fumes Stationary Filter
- 58 -
Instruction Manual - EN
rev.: 0
Status as of: 04/2014