Machine Start And Stop; Machine Operation - Nilfisk BR 601 Manuel D'utilisation

USER MANUAL

MACHINE START AND STOP

Start
1. Prepare the machine as shown in the previous
paragraph.
2. Turn the ignition key (12, Fig. B) to "I" without pressing
the forward gear pedal (3, Fig. C). Check if the green
warning light (7a, Fig. B) turns on.
If the yellow or red warning light (7b o 7c, Fig. B) turns
on, turn the key back to "0", then charge the batteries
(see the procedure in Maintenance chapter).
3. Drive the machine to the working area, by keeping the
hands on the steering wheel and pressing the pedal (3,
Fig. C) on the front side to move forward and on the rear
side to move backward.
The drive speed can be adjusted from zero to maximum
speed according to the pressure on the pedal (3, Fig. C).
NOTE
The seat (25, Fig. C) is equipped with a safety
sensor, which allows the machine to be moved
with the pedal (3, Fig. C) only when the
operator is on the driver's seat.
NOTE
The machine is equipped with an anti-tilting
safety system that reduces the speed when
turning, irrespectively of the pressure on the
gear pedal.
The reduction of speed when turning is not a
malfunction but a characteristic that improves
the machine stability in every condition.
4. Lower the brush/pad-holder deck and the squeegee by
pressing the switch (6, Fig. B).
5. Press the solution flow control switches (10, Fig. B)
according to the type of cleaning to be carried out.
6. Start scrubbing, by turning the steering wheel (2, Fig. C)
and moving the machine forward by pressing the pedal
(3).
7. If necessary, adjust the working speed using the
maximum speed adjuster (11, Fig. B). The adjuster is
enabled only when the machine is operating (scrubbing
and/or drying).
12
Stopping the machine
8. Release the pedal (3, Fig. C).
9. It is not necessary to lock the machine during stopping
or parking, because the electromagnetic brake (27, Fig.
C) turns on automatically when the gear pedal is not
pressed.
10. Lift the brush/pad-holder deck and the squeegee by
pressing the switch (6, Fig. B).

MACHINE OPERATION

1. Start the machine as shown in the previous paragraph.
2. If necessary, adjust the solution flow by pressing the
switches (10, Fig. B).
Detergent flow percentage adjustment
(For machines with EDS-ECO Dosage Solution (optional))
3. Turn on the mixing system by pressing the switch (9, Fig.
B): the relevant warning light turns on.
4. Press again the switch (9, Fig. B) and hold it (for about 5
seconds) until the warning light flashes.
5. Read on the display (8, Fig. B) the previously set
detergent percentage value and, if necessary, change it
by repeatedly pressing the switch (9) until the desired
value is displayed.
6. Wait for the switch warning light (9, Fig. B) to stop
flashing: the new percentage value is now set.
909 6160 000(2)2006-10 A