Machine Start And Stop - Nilfisk SC400 Mode D'emploi

ENGLISH

MACHINE START AND STOP

Starting the machine
1. Prepare the machine as shown in the previous paragraph.
2. Lower the squeegee (11) with the pedal (19).
3. Turn the knob (62) to turn on the machine and select one of the programs according to the following table:
Selection Symbol
(63)
(64)
(65)
4. In the first 5 seconds after turning on the machine, the LEDs (68) indicate the battery charge status. If the green LED turns
on, the machine is ready to be used. If the yellow or red LED turns on, the batteries must be charged (see the procedure in
Maintenance chapter).
NOTE
If the batteries are charged, the LEDs indicate the battery charge level only in the first 5 seconds after machine start-up.
When the batteries are nearly or fully discharged, the battery charge level is constantly shown. In this case, to see the
solution flow, the push-button (67) must be pressed.
5. Press the solution flow push-button (67) to change the solution quantity. Green LEDs (68) indicate the flow quantity according
to the following table:
LEDs on (68) Symbol
6. To start scrubbing/drying, keep the hands on the handlebar (2) and press both the enabling push-button (69) and the brush
activation levers (70).
Stopping the machine
7. Release the brush levers (70) and the enabling push-button (69).
8. Turn the knob (62) to "0" position to switch off the machine.
9. Engage the positioning pin (24) and activate the machine parking device (23a) to keep the brush/pad-holder lifted (see Fig. 5).
10. Make sure that the machine cannot move independently.
NOTE
Each time that the machine is turned off, the solution flow program turns automatically to "ECO" level, to reduce water
consumption.
CAUTION!
In case of immediate necessity and to stop all machine functions, disconnect the battery connector (29).
Reset the machine functions by connecting again the connector.
14
USER MANUAL
Program
Scrubbing and drying.
Brush - vacuum system - solution flow activation
Scrubbing.
Brush - solution flow activation
Drying.
Vacuum system activation
Setting
Minimum "ECO" solution flow.
Medium solution flow.
Maximum solution flow.
Closed solution flow.
SC400 - 9099612000