Weighing With Preset Tare Values; Hold Function - Soehnle Professional 6808 Mode D'emploi

6. Operations

6.4 Weighing with preset tare values

Press [ON/OFF/ZERO] with no load on the scale.
f
Press and hold the [TARE/PRESET] key until the NET indicator flashes and
f
"Pr.Tare" shows up in the display.
Input the tare weight using the arrow keys
f
(already known the weight of the wheelchair).
After inputting the tare weight, press the [TARE/PRESET] key to confirm.
f
The NET indicator will be lit on the display.
Note: Tare weight must be greater than zero and less than the scale's
maximum capacity.
Put the patient and the additional weight (e.g. in the wheelchair) to be
f
weighed onto the scale platform. The net weight will be displayed.
To exit preset tare mode, remove all weight from the scale. The display will
f
show a negative weight. Press the [TARE/PRESET] key to return the display
to zero, eliminating the weight of the container.
Note: The indicator can only save one tare weight. Entering a new tare
weight will automatically replace the old one.

6.5 Hold function

The Hold function is being used if you like to hold the results at the display after
the weight/load has been removed from the scale. Use this button to take care of
the patient first and then note the weight.
Press [HOLD/SETUP] while scale is under load.
f
"HOLD" is being displayed at the screen.
f
The weight remains saved in the display after unloading the scale.
f
For deactivation of the Hold function press again the HOLD/SETUP key.
f
22