Operation; Switch On; Weighing; Zeroing - Soehnle Professional 7845 Mode D'emploi

10. Operation

10.1 Switch on

10.2 Weighing

10.3 Zeroing

10.4 Taring

With the scale is unloaded, press the on/off key.
During the test routine, the version status is briefly displayed.
This is not an error message.
Then the display switches to zero.
The scale is ready to weigh.
Load the scale. The display shows the gross weight.
Press the zeroing key to correct small deviations from the zero point, e.g. due to
contamination of the balance.
Zero setting range: -1 to +3% of the weighing range.
Manual Tare
Place towels or other supports on the weighing platform. Then press the tare
key.
The display goes to zero. The display shows „Net" for „Net".
Taring is possible within the entire weighing range.
Manual tare input
You can enter a fixed tare value manually with the manual tare input. (Setting
the function key: see separate description User mode 7835, art. no.
470.702.124). If required, this document can be requested from Soehnle
Industrial Solutions or from your local scale dealer.
Press the function key
Set the desired tare weight with the tare or function key. Pressing briefly causes
the value to be incremented/decremented one by one. With permanent
pressure the display runs up or down.
Press the Send key to finally accept the set value.
10
47