Replacing A Fuse - GGP ITALY SPA 72 Manuel D'utilisation

6.4.4 Replacing a fuse

The machine is fitted with fuses
(1) with different capacities and
functions. Specifically:
– 10 A fuse = protects the main
and power circuits of the elec-
tronic board. When it blows,
the machine stops and the
dashboard light switches off.
– 25 A fuse = protects the bat-
tery charger circuit. When it
blows, the battery gradually runs out and the machine will
have problems starting.
The fuse capacity is indicated on the fuse.
With Honda engine
– T-6.3 A fuse (delayed) (2) =
protects the main and power
circuits of the electronic
board. When it blows, the
machine stops and the
dashboard light switches off.
– 15 A fuse (2a) = protects
the battery charger circuit.
When it blows, the battery
gradually runs out and the
machine will have problems
starting.
IMPORTANT
by one of the same type and ampere rating, and never with
1
one of another rating.
If problems persist, contact Your Dealer.
6.4.5 Dismantling, replacing and remounting the blade
WARNING!
dling the blade.
WARNING!
be replaced; never try to repair it! ALWAYS USE ORIGI-
NAL BLADES BEARING THE SYMBOL
Only blades with the following codes must be used on this
machine:
2a
(15 Amp)
IMPORTANT
together, especially when there are slight differences in wear.
2
(T-6.3 Amp)
A blown fuse must always be replaced
Always wear work gloves when han-
Damaged or bent blade must always
84109503/0 or 84109502/0
Both of the blades should be replaced
!
EN 29