Assembling Instructions; Attaching/Adjusting The Carrying Strap; Mounting The Attachments - Grizzly EKHS 500-45 2in1 Traduction De La Notice D'utilisation Originale

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 31
GB
this electric tool may present the following
hazards:
a) Cuts
b) Ear damage if working without ear
protection.
c) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held
or maintained properly.
Warning! During operation, this
electric tool generates an electro-
magnetic field which, under cer-
tain circumstances, may impair the
functionality of active or passive
medical implants. To reduce the
risk of serious or lethal injuries,
we recommend that persons with
medical implants consult their doc-
tor and the manufacturer of their
medical implant before operating
the machine.

Assembling instructions

Pull out the power plug before car-
rying out any work on the equip-
ment.
If the tubes of the device are not
fitted into each other and are cor-
rectly locked, the device cannot
be switched on. A safety switch
prevents operation!
Use only original parts.
Attaching/adjusting the
carrying strap
1. Attach the snap hook of the
carrying strap (16) to the carry-
ing eye (11) on the device.
62
2. Put on the carrying strap (16)
(see image
3. Adjust the strap length such
that the carrying eye (11) is at
hip height.
4. In addition, you can adjust
the height of the eyelet for the
shoulder strap (11) on the tel-
escopic tube after loosening the
Phillips screw on the eyelet.
Mounting the attach-
ments
Danger of pinching!
Make sure that the bolts (
13/10) are firmly and securely
in place before you turn on the
unit.
Working with the telescopic tube:
Open the operatung unit lock (10).
Insert the telescopic tube (4) together
with the operating unit (5) as far as
they will go.
Only one position is possible.
Close the operating unit lock (10).
Open the cutting head lock (13). Push
the telescopic tube (4) together with
the cutter head (2) as far as they will
go.
Only one position is possible.
Close the cutting head lock (13).
Working without the telescopic tube:
Open the cutting head lock (13). Push
the cutting head (2) and operating
unit (6) together as far as they will go.
Only one position is possible.
Close the cutting head lock (13).
).

Publicité

Table des Matières
loading

Table des Matières