Inserting The Drive Battery In The Vehicle; Connecting The Drive Battery - Reely 23 98 30 Notice D'emploi

d) Inserting the Drive Battery into the Vehicle
Remove the hook-and-loop tapes of the battery holder. Insert the drive battery into the battery holders. Tighten the
hook-and-loop tapes to secure the battery in the battery holder.
Attention!
Do not connect the drive battery yet! Read the following section e) first and proceed as described there.
e) Connecting the Drive Battery
Step 1:
To prevent a sudden starting of the wheels and therefore an uncontrolled starting of the model (e.g. if the
trimming for the drive is maladjusted or neutral position is not programmed correctly, see chapter 10. a),
place the model vehicle on a suitable surface (or starting box), so that the wheels can turn freely. Do not
reach into the drive. Do not hold the wheels! Risk of injury!
Step 2:
Check the position of the on/off switch of the speed
controller (see circle in the figure on the right) and place
it in the „OFF" position (switched off).
Step 3:
Switch on the transmitter if you haven't done so already. Check its function (e.g. operation display of the transmitter).
Also observe the separately enclosed operating instructions for the remote control system.
Step 4:
Put the on/off switch for the receiver power supply (see
circle in the figure on the right) in the „ON" position.
44