Reely 23 98 30 Notice D'emploi page 45

Step 5:
Disconnect the plug connector in the plus line, see
circle in the figure on the right.
Observe that the two plug connections do not touch
and that they do not touch any other metal parts of the
vehicle (e-g- the chassis) either!
Step 6:
Connect a fully charged 6-cell LiPo drive battery (rated
voltage 22.2 V) to the battery plug contact, see circle
in the figure on the right.
Always ensure correct polarity (red cable = plus/+, black
cable = minus/-).
Step 7:
Now connect the plug connection disconnected in step
5 again, see circle in the figure on the right.
A protective impedance is integrated below the round
socket's shrink hose. It and the procedure described
above in steps 5 to 7 prevents light arc when
connecting the drive battery.
Speed controller commissioning is described in the
next section f).
45